tag:blogger.com,1999:blog-4194361679661299683.post5623297362356239114..comments2023-09-15T08:30:37.388+01:00Comments on antonalyptic: Clive DriveIrish Dodohttp://www.blogger.com/profile/08908933926438532887noreply@blogger.comBlogger7125tag:blogger.com,1999:blog-4194361679661299683.post-31343559675391728562019-02-04T14:28:04.071+00:002019-02-04T14:28:04.071+00:00I have emailed you, Julio. Thanks for your interes...I have emailed you, Julio. Thanks for your interest.Irish Dodohttps://www.blogger.com/profile/08908933926438532887noreply@blogger.comtag:blogger.com,1999:blog-4194361679661299683.post-37412472075970246932019-02-03T16:12:07.257+00:002019-02-03T16:12:07.257+00:00the interface do not work of all, i can Format and...the interface do not work of all, i can Format and Save from Basic. When press 1 do not save any file, when press 3 saves a 14K BIN file instead of 7k named Keymaster(n).bin. the ROM version is 1.00.<br />I have observed that in the schemes several mods are referenced. I have compared the components that exist on the board against the schemes you have and there are several values in the resistors that are permuted or the value does not match at all.<br />When it refers to the ALS type only for IC3 and ic13? or all from IC3 to IC16.<br />It is also possible that something is not doing well to make a memory dump but the instructions are short for me, the repairs that I had to perform have been: the floppy disk transformer had loose wires, the bus connector It was split and a loose cable that connects both plates. tune the connector of the folded floppy disk drive, and cleaning the printed circuit boards, some resistors are far from the value of the scheme and observing the connector of the disk only 10 signals arrive at the floppy disk, the power is independent of the cable of the floppy disk drive. SELIN (pin15 nc) which should not be important since from the basic could record a short program.<br />There are too many integrated circuits welded directly to board, where should I start desoldering ?, the SRAM is good is 6116-10, not 150, the EPROM 2764 is read and tested.<br />If you can provide some additional information that you have will be welcome, this interface must be preserved.<br />jrmedinam@gmail.comAnonymoushttps://www.blogger.com/profile/14884094239352089469noreply@blogger.comtag:blogger.com,1999:blog-4194361679661299683.post-58010648072656817862019-02-03T09:15:10.137+00:002019-02-03T09:15:10.137+00:00Only 48K. I did some work later on an adapter to c...Only 48K. I did some work later on an adapter to convert a 48K Spectrum to 128K but I have retained no details and cannot remember.Irish Dodohttps://www.blogger.com/profile/08908933926438532887noreply@blogger.comtag:blogger.com,1999:blog-4194361679661299683.post-29448618970216689622019-02-02T23:39:18.305+00:002019-02-02T23:39:18.305+00:00With some service and a replacement belt drive, a ...With some service and a replacement belt drive, a Clive Drive v1.00 works again!!<br />The two pcbs are very well routed ;-D.<br /><br />the question...128kb compatible? or only 48kb?<br />regards.<br />Anonymoushttps://www.blogger.com/profile/14884094239352089469noreply@blogger.comtag:blogger.com,1999:blog-4194361679661299683.post-71176541654487454452018-10-11T12:13:46.909+01:002018-10-11T12:13:46.909+01:00Lovely footnote brought to my attention after goog...Lovely footnote brought to my attention after googling because of https://twitter.com/yorecomputer/status/1050337304500469765Unknownhttps://www.blogger.com/profile/14520008929288573949noreply@blogger.comtag:blogger.com,1999:blog-4194361679661299683.post-81321771003608678852015-09-09T15:05:01.886+01:002015-09-09T15:05:01.886+01:00No, not a recent remake. I don't think I have ...No, not a recent remake. I don't think I have the code any more so could not easily reproduce it, even if I found a supply of quick-disk drives. Do you still use the Spectrum?Irish Dodohttps://www.blogger.com/profile/08908933926438532887noreply@blogger.comtag:blogger.com,1999:blog-4194361679661299683.post-25095959325470766602015-09-09T13:16:58.297+01:002015-09-09T13:16:58.297+01:00So the links you've included are about some ol...So the links you've included are about some old stock drives and not some recente remake? I was not aware of this drive and I find it rather interesting. Congratulations on your work.João Diogo Ramos - LOAD ZXhttps://www.blogger.com/profile/03856271355886715864noreply@blogger.com